Spraynet
Cleaning spray for instruments and equipment.
Dissolves impurities.
Comply with the following recommendations and the instruction manual accompanying each instrument.

External cleaning
It is recommended to use a clean cloth sprayed with Spraynet to clean and maintain the surfaces of hoses, cables, non-watertight equipment and housings and electric motors. Direct spraying is perfectly suitable for all contra-angles, handpieces, turbines and air and brushless electric motors.

Inadvisable products: disinfectants containing acetone, chlorine or bleach.

Internal cleaning
Warning: Any instrument cleaned internally with Spraynet shall mandatorily be relubricated before storage or sterilisation.
See maintenance instructions.
This procedure will ensure that the
instrument runs well during each
operation and for many years.

Important
Unsuitable for Eolia turbines.

Lubricate before each sterilization or at least twice a day.
- Remove the bur and insert the tip of the greaser as far as it will go.
The dose required corresponds to a half-turn of the  knurled rear section. Use the reference marks.
- Put a bur back on, connect the air supply and operate the turbine for about 10 seconds.

Spray Lubrifluid
New, even more effective lubricant solution, extends the life of your instruments and ensures their satisfactory operation.

Suitable for:

• Straight and
  contra-angle handpieces

• Aquilon air motors

• MX and BASCH motors

• Ball-bearing turbines

Important: Unsuitable for non-sterilisable brush motors

Lubricate before each sterilisation or at least twice a day.
- Lubrication with the standard nozzle: squirt for 1 second through the back
of the instruments.
- Standard nozzle and small adapter, lubricate the MX and BASCH motors
from the front for 1 second.
Lubricate the air motors through the back for 0.5 to 1 second.